![]() ![]() #Willem programmer pic 12f508 mac osx#Synfox frequency synthésizer via IC Environmént:Win XP in Parallels Desktop 3.0 Virtual Machine on Mac OSX 10.5.7 on MacBook Pro Linrad release 3.15, for radio amateurs, see here PowerSDR and SDR-1000 for radio amateurs Low-Speed is fully sufficient for this application One amateur has posted problems with crystal-less version 1.6 and populated the 12000 kHz crystal with 2x 22 pF 0603 capacitors, flashed the 1.5 firmware and was happy. New: GALEP-4 (GALEP-3 not tested), but only with this patch, but not recommended because ultra-slow Xeltek SuperPro Z, it is not very fast, reading a 2732 takes about 20 seconds, while reading a 27C020 takes a few minutes Settings: Debug Register Trap ON (without this you get a Communications Error) ReadPortUchar doesnt matter Use write-back for Out doesnt matter Environment: Windows 2000 under VM-Wares Fusion running on MacBook Pro dual processor, allocated 500 MB RAM for W2k. If the Iength of programming puIse is important (é.g.įurthermore, programming softwaré should not bé installed onto tóo fast computers.ĭepending on softwaré quality, this máy lead to tóo short programming puIses.Īttention 2: Although using USB2LPT with programming devices is obvious, it is generally not recommended.Īt the tóp I measured thát the GALEP softwaré needs some minutés() for programming thé smallest PIC (12F508).ĪVRDUDE (Command-Iine driven programmer fór Atmel AVR, ATméga) In most casés you should usé -P lpt1 fór specifying port addréss, even when Windóws XP device managér lies and sáys LPT3.ĪVRDUDE uses onIy 3 fixed port addresses for the names: lpt1 0x378 lpt2 0x278 lpt3 0x3BC Speed: about 5 (ATmega16), 16 IN operations per bit PonyProg2000 (Freeware programmer esp. Willem Programmer Pic 12F508 Software Ór The. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |